New command: show optic

[wblackcenic]

Please add an additional command under the Port tab: 'show optic'

There is one caveat about this command. This command doesn't let you specify the individual port but instead asks for a Slot number instead. As such, if someone was to press 'show optic' on ethernet 3/1, the command would need to run as 'show optic 3'

[jonstout]

In order for the port selection to specify the required slot, we'll need to do a little work on the backend. We can track that work here.

If the command is needed right away, it can be added by adding a slot number parameter to the show optic command in access_policy.xml. The user would then manually specify the slot number.

[wblackcenic]

This isn’t a critical request. I’d rather not require the end-user provide the module number, so rather than that, we can wait for this feature until a later date. Thanks, Will

…

On Apr 12, 2018, at 11:28 AM, Jonathan Stout ***@***.***> wrote: In order for the port selection to specify the required slot, we'll need to do a little work on the backend. We can track that work here. If the command is needed right away, it can be added by adding a slot number parameter to the show optic command. The user would then manually specify the slot number. — You are receiving this because you authored the thread. Reply to this email directly, view it on GitHub <#166 (comment)>, or mute the thread <https://github.com/notifications/unsubscribe-auth/AglpmtkrOJpTB6yu29az3fXYXG2GDU6tks5tn5zfgaJpZM4TSDra>.