HP status idle when doing thermal disinfection

[ChrisMisker]

See the above image. My hp status is idle instead of domestic water when doing the thermal disinfection run. Yellow/orange is domestic water.

This is annoying, because I use the hp status to set a utility meter to measure my COP when heating and DHW.

[rhammen]

I think this is a bug in the Luxtronik firmware: I expect the heatpump reports it is idle when it is actually doing thermal desinfection...

Please create a diagnostics file somewhere during the thermal desinfection run, not to close too the start or end.
I'll then see if there is a way to adress this in the integration, or that you should report the issue to your heatpump dealer/manufacturer.

[ChrisMisker]

config_entry-luxtronik2-01JD1GEKK2RNFKM16CPWPM2X05.json

Yeah, I see in here that ID_WEB_WP_BZ_akt is set to heating, instead of domestic water. The "remote control" in the webserver is showing it's doing thermal disinfection, but I guess it's not updating the status properly.

Darn. So this probably means I have to create my own status sensor, where I check for a couple of things (disinfection set to current day, DHW had been running recently, high power usage, etc.. and then see if I can set that to DHW).